Gingham Cane using Darlin' Designer Disks

	[ Home ] [ Up ] "Don't compete. CREATE. Find out what everyone else is doing and then don't do it." Joel Weldon
Home of the

Polymer Clay by

Tamila J. Darling

Artist-Designer-Instructor

featuring the

This cane was constructed using the small square

Darlin' Designer Disk™ from the Geometric Kit


	STEP ONE Extrude one length each of a contrasting color and two lengths of a third color. Most gingham prints utilize a shade in between the light and dark colors as shown above.	STEP TWO Cut the clay into two even sections.


	STEP THREE Place one length	STEP FOUR Cut this length into two even sections and continue to form the pattern until it looks like the final photo below.


FINISHED GINGHAM

Kindly respect the work of the artist and/or guest artists who appear on this site.

All photographs and each piece of work is copyrighted by the artist and/or guest artists who have provided

them. Any use of these without written permission of those artists is prohibited, unless otherwise noted on this site.

Send e- mail to Tamila with questions or comments

WebRing

Home - About - Privacy

Poly Ring

[ Join Now \| Ring Hub \| Random \| << Prev \| Next >> ]